RODE NT2A CONDENSER MICROPHONE STUDIO BUNDLE
INCLUDING SM6 SHOCK MOUNT & POP FILTER, CABLE AND MORE..
Designed and manufactured in Sydney, Australia - The new NT2-A is a professional large capsule (1") condenser studio microphone with variable pick-up pattern, Variable high pass filter and variable pad. These features provide greater creative control and versatility. Three 3-position switches located on the mic body provide the freedom to step from Figure 8, Cardioid or Omni polar pick-up patterns; from a flat response to either 80 Hz or 40 Hz high-pass filter and a Pad adjustment of 0 dB, -5 dB or -10 dB attenuation.
The NT2-A's variable controls allow switching between Omni, Figure 8, and Cardioid polar patterns. The three position high-pass filter provides a flat response or an 80Hz and 40Hz high pass filter to be selected. Finally the microphones Pad can be switched between 0 dB, -5dB and -10dB. The NT2-A comes in a soft pouch with an M2 stand mount.
The Australian designed and manufactured HF1 1" edge terminated, gold sputtered, dual 5 um diaphragm capsule.
3-position variable polar pattern: Omni, Cardioid & Figure 8; all controlled on the mic.
3-position variable high-pass filter: Flat, 80 Hz or 40 Hz.
3-position variable pad: 0 dB, -5 dB or -10 dB.
Ultra low noise, transformerless SMT circuitry.
Wide dynamic range.
High strength heat-treated steel mesh head.
Durable satin nickel finish.
Internal capsule shock mounting.
Supplied complete with soft pouch and clip.
FREE shock mount and pop filter
FREE professional 20' microphone cable
FREE microphone dust cover
Omnidirectional Polar Response Figure 8 Polar response Cardiod Polar Response
(Picks up all sides evenly) (Picks up the front and rear and rejects the sides) (Picks up the front & sides and rejects the rear)
Externally polarized 25 mm (1") dual diaphragm.
Multi-pattern (see graphs over).
20 Hz ~ 20 000 Hz (see graphs above)
Signal/Noise ratio DIN/IEC 651:
87 dB (1 kHz rel 1 Pa; per IEC651, IEC268-15)
7 dBA SPL (per IEC651, IEC268-15)
147 dB (@ 1% THD into 1 kO)
157 dB (@ 1% THD into 1 kO) - pad at maximum
Sensitivity at 1 khz into 1 kO:
-36 dB re 1 Volt/Pascal (16 mV @ 94 dB SPL) +/-2 dB
Maximum output voltage:
+16 dBu (@ 1% THD into 1 kO)
Dynamic range of the mic. amplifier DIN/IEC 651
140 dB (per IEC651, IEC268-15)
Power (Supply voltage):
48 Volts (P48)
3 pin XLR, balanced output between pin 2(+) and pin 3(-).
Pin 1 ground
860 grm (4.23 oz)
209 mm (8.228")
55 mm (2.165")
1 year with free extension to 10 years following registration
Others Also Bought
More From This Category